General Safety Notes - powermatic PM1500 Gebrauchsanleitung

The proper use also includes compliance with the operating and
maintenance instructions given in this manual.
The machine must be operated only by persons familiar with its
operation, maintenance and repair and who are familiar with its
hazards.
The required minimum age must be observed
The machine must only be used in a technically perfect condition.
When working on the machine, all safety mechanisms and covers
must be mounted.
In addition to the safety requirements contained in this operating
instructions and your country's applicable regulations, you should
observe the generally recognized technical rules concerning the
operation of woodworking machines.
Any other use exceeds authorization.
In the event of unauthorized use of the machine, the manufacturer
renounces all liability and the responsibility is transferred
exclusively to the operator.

3.2 General safety notes

Woodworking machines can be dangerous if not used properly.
Therefore the appropriate general technical rules as well as the
following notes must be observed.
Read and understand the entire instruction manual before
attempting assembly or operation.
Keep this operating instruction close by the machine, protected
from dirt and humidity, and pass it over to the new owner if you
part with the tool.
No changes to the machine may be made.
Daily inspect the function and existence of the safety appliances
before you start the machine.
Do not attempt operation in this case, protect the machine by
unplugging the mains cord.
Before operating the machine, remove tie, rings, watches, other
jewellery, and roll up sleeves above the elbows.
Remove all loose clothing and confine long hair.
Wear safety shoes; never wear leisure shoes or sandals.
Always wear the approved working outfit
- safety goggles
- ear protection
- dust protection
Downloaded from www.Manualslib.com manuals search engine
Do not wear gloves while operating this machine.
Wear work gloves for the safe handling of sawblades.
Observe the chapter "save operation" in this manual.
Control the stopping time of the machine, it may not be longer
than 10 seconds.
Work only with a sharp and flawless sawblade.
Work only with fence well tightened.
Insure that the workpiece does not roll when cutting round pieces.
Use suitable table extensions and supporting aids for difficult to
handle workpieces.
Always lower the blade guide close to the workpiece.
With the machine table is inclined use the fence and position it on
the bottom side only.
Always hold and guide the workpieces safely during machining.
Remove cut and jammed workpieces only when motor is turned
off and the machine is at a complete standstill.
Install the machine so that there is sufficient space for safe
operation and workpiece handling.
Keep work area well lighted.
The machine is designed to operate in closed rooms and must be
placed stable on firm and levelled ground.
Make sure that the power cord does not impede work and cause
people to trip.
Keep the floor around the machine clean and free of scrap
material, oil and grease.
Stay alert!
Give your work undivided attention.
Use common sense.
Keep an ergonomic body position.
Maintain a balanced stance at all times.
Do not operate the machine when you are tired.
Do not operate the machine under the influence of drugs, alcohol
or any medication. Be aware that medication can change your
behaviour.
Never reach into the machine while it is operating or running
down.