powermatic PM1500 Gebrauchsanleitung Seite 8

The fence profile can be installed in two positions, vertically (Fig 6)
or horizontally (Fig 7).
Horizontal position is useful for smaller workpieces, for narrow
shallow cuts.
(Note: The scale cannot be used with horizontal fence).
Fence scale:
Move the fence assembly flush to the sawblade and set the
pointer to zero. If cursor is not at zero, loosen two screws (D, Fig 8)
to adjust.
Check the clearance between the table and the fence. The fence
should not rub on the table surface but be slightly above (Fig 9).
Use the nylon screws (C, Fig 6) to adjust.
Downloaded from www.Manualslib.com
Fig 6
Fig 7
Fig 8
manuals search engine
Fig 9
The table has been aligned at the factory, so that the mitre slot is
parallel to the saw blade.
Use a long ruler against the saw blade body to inspect (Fig 10).
If mitre slot is not parallel, loosen the four screws (E, Fig 11) to
adjust the table
Fig 11
Make sure the fence is parallel to the miter slot (Fig12)
Fig 12