powermatic PM1500 Gebrauchsanleitung Seite 11

Resaw guide:
The resaw guide allows you to compensate blade drift.
The feed direction can be lined up to follow the cut.
For resawing attach the guide to the fence with the lock knob.
Position the guide so that it is centred with the blade teeth. (Fig
20).
Mitre gauge:
Place the mitre gauge in the table T-slot.
The mitre gauge bar has two slots, each with a set screw. Rotate
these set screws (Fig 21), to eliminate any unwanted play in the T-
slot.
The mitre gauge has positive stops for 90° and 45°:
If the stops need adjustment, loosen the lock nuts (D, Fig 22) and
adjust the stop screws (E).
Downloaded from www.Manualslib.com
Fig 20
Fig 21
Fig 22
manuals search engine
Ripping (Fig 23)
Fig 23
Crosscutting (Fig 24)
Fig 24
Resawing (Fig 25)
Fig 25
Resawing with resaw guide (Fig 26)