Troubleshooting; Environmental Protection - powermatic PM1500 Gebrauchsanleitung

POWERMATIC part number: PM1500-045
The table insert may not project above table surface.
Saw blades:
The servicing of sawblades should only be performed by a trained
person.
Only use sharp and properly set sawblades.
Lubrication points:
Periodically apply a light all-purpose grease to rack and pinion (Fig
47)
To the table trunnions (Fig 48).
To the blade tension screw.
Downloaded from www.Manualslib.com
Fig 46
Fig 47
Fig 48
manuals search engine
Fig 49
Note:
Bearings on the band saw are pre lubricated and sealed and do not
require attention.
9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload has reacted-
Wait and start again.
*Wheel covers not closed-
*Saw blade not tensioned-
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*dust on wheel-
clean tires.
*sawblade has cracks-
replace sawblade immediately
Cut is not square
*Table stop setting wrong.
*Blade guide setting is bad
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*Blade guide setting is bad
*Blade tension too low
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.

10. Environmental protection

Protect the environment.