Proper Usage; Technical Data; Putting Into Operation - EINHELL GAS 4,8 FG Bedienungsanleitung

Anleitung GAS 4,8 F Praktiker
GB

3. Proper usage

The Accu Shear GAS 4.8 FG have been designed
for the cutting of grass edges and small grass
surface in private gardens/hobby area.
It is absolutely necessary to observe the
manufacturer's operating instructions to ensure the
unit's proper functioning.
The operating instructions als contain advice for
service, maintenance and repair.
Caution!
For safety reasons, the unit should not be used
for cutting hedges or chopping in the sense of
composting.

4. Technical data

Cutting width
Operating time per charge
Cutting length per charge
NC battery
Power pack:
Mains voltage
Output:
Nominal voltage
Nominal current
Nominal power

5. Putting into operation

Charging the NC battery
1. Open the lid of the battery box and pull the
battery out of the handle.
2. Check that the mains voltage specified on the
rating plate is the same as your local mains
voltage. Connect the charging cable to the
charging adapter and plug the charger in a
socket-outlet. The green LED on the charging
adapter indicates that charging voltage is
available.
3. Insert the battery in the charging adapter. The red
LED indicates that the battery is being charged.
The charger does not switch off automatically
when the battery is fully charged. An empty
battery requires a maximum of 12 hours to be
charged. Charging takes less time according to
the level of the residual charge. While the battery
8
13.11.2001 11:12 Uhr
If you find it impossible to charge the battery, please
check
-
-
If you still fail to charge the battery, please return
to our Customer Service Centre.
Timely recharging of the NC battery will help to pro-
long its useful life. This is particularly important when
you notice that the battery-powered grass cutter is
beginning to cut less efficiently.
70 mm
max. 40 min
Never allow the battery to discharge fully. You will be
left with a defective NC battery!
ca. 800 m
4.8 volts / 1300 mAh
Using the Shears
The area to be cut should first be cleared of stones
230V ~ 50 Hz
and other solid objects. Pull the knife guard toward
the back until it latches firmly in place. The starting
inhibitor prevents your Einhell grass cutter from
being switched on unintentionally. To start up the
6 V
battery-powered grass cutter, slide the starting inhibi-
300 mA
tor towards the back to unlock it. Then press the ON
button. When you are finished with your work, relea-
1.8 VA
se the catch and push the knife guard back to the
front again in order to rule out injury.
Cutting grass:
Simply push the cutter on its wheels over the ground.
This ensures a constant even cutting height. The
large contact surface makes the shears easy to
handle. The best cutting results are obtained with dry
grass. However, there is no electrical danger when
the grass is for instance damp.
When cutting power drops considerably, re-charge
shears immediately to prevent cells from becomming
completely empty.
This switching device that have been installed on
the unit by the manufacturer may not be removed
or by-passed, e.g. by binding a switch to the
handle. This may cause fatal injury and the unit
does not switch off automatically.
Seite 8
is being charged it may become warm. This is
normal.
whether there is voltage at the socket-outlet,
whether the charging contacts on the battery
charger make proper contact.
the power pack
the charging adapter
and the battery