Items Supplied; Technical Data; Safety Regulations - EINHELL Bavaria BBH 626 Bedienungsanleitung

Anleitung_BBH 626_SPK 1
1. Description
(Fig. 1)
1 Dust guard
2 Fastening sleeve
3 On-Off switch
4 Handle attachment
5 Cap for carbon brush
6 Depth stop
7 Hammer stop
8 Drill stop

2. Items supplied

- Case
- Hammer drill
- Depth stop
- Auxiliary handle
- Dust cap

3. Technical data

Voltage: 230 V ~ 50 Hz
Power consumption:
Idle speed:
Number of impacts: 2700 min
Drilling performance
(max.): concrete/stone 26 mm
Weight:
Vibration level:
Sound intensity level:
Acoustic capacity level:
Protection class:
Noise and vibration values measured according to
EN 50144-2-6

4. Safety regulations

Important! To protect yourself from the risk of electric
shock, injury and fire when using an electric tool, it is
imperative to take the following basic safety
precautions. Read and note these instructions
before you use the machine.
Check the voltage (volt) marked on the rating
plate.
When using cable drums, run all the cable off the
drum. Minimum conductor cross section: 1.5 mm
When using the electric hammer drill outdoors,
connect to the power supply with a type H07RN-F
3G 1.5 mm 2 extension cable and rain-water-
protected plugs in proper working order.
18.02.2003 15:26 Uhr Seite 7
Make sure of your footing on ladders and
scaffolding when drilling free-handed.
Use a line detector to localize lines in walls with
concealed electric, water or gas lines. Avoid
touching live components or conductors.
Wear ear muffs to protect your hearing. Loss of
hearing can be a gradual process!
Wear goggles and use a dust mask on jobs
generating dust.
Do not use in areas where there are vapours or
flammable liquids.
Always pull the plug out of the socket before
cleaning or making changes to the machine.
Protect the power cable from damage. Oil and
acid can damage the cable.
Never overload the machine.
Secure all workpieces sufficiently.
Important! It is imperative to follow all national
safety regulations concerning installation,
operation and maintenance.
Chisel bits and drill bits may be flung out of the
machine accidentally and cause serious injury:
Before starting to work, always check that the
620 Watt
chisel or drill bit is properly locked in the chuck.
750 min -1
Examine the chuck regularly for signs of wear or
-1
damage.
Never start up a hammer tool until it pressed
against a workpiece (wall, ceiling, etc.).
When you are finished, unplug the hammer drill
5,3 kg
from the electric supply and remove the chisel or
2
5,6 m/s
drill bit from the machine.
99 dB(A)
Always disconnect the hammer drill from the
107 dB(A)
electric supply before you change a chisel or drill
® / II
bit.
Protect your eyes and other workers from flying
particles and splinters. Wear a helmet! Set up
partition walls!
Wear work gloves to protect fingers from bruising
and grazing.
Vibrations can injure the hand-arm system. Keep
exposure to vibrations as short as possible.
Always lead the mains cable away backwards
from the device.
Store the device where it is inaccessible to
children.
When carrying out work, always hold the device
with both hands and ensure that you have a
stable standing position.
2 .
You will find further safety instructions for elec-
tric tools in the enclosed booklet.
GB
7