Installing The Driver - Panasonic CF-VEB Serie Bedienungsanleitung

CAUTION
Do not attempt to move the port replicator when it is connected to the computer.
Hold down the bottom of the computer when opening
the display. If you open the display without holding
down the bottom of the computer, the computer may
be disconnected from the port replicator.
Do not turn the display while the computer is connected to the port replicator.
Set the port replicator up on a flat surface. Setting up the port replicator on an uneven
surface can result in poor contact.
Do not use the port replicator in a location where it will be subject to vibration, such as
while riding a bike, motorcycle, or car. The computer may disconnect from the port
replicator and malfunction as a result.
If the computer malfunctions while the port replicator is connected, refer first to the
"Dealing with Problems (Advanced)" in the computer's "Reference Manual". If you
still are unable to solve the problem, turn off the computer, disconnect the port replicator
( page 11), connect the AC adapter to the computer, and check to see if the com-
puter operates normally. If the computer operates normally, the port replicator may be
malfunctioning. Contact Panasonic Technical Support.

Installing the Driver

If your computer is a model in the CF-18Bxxxxxx series, install the driver by following the
procedure below after connecting the computer to the port replicator. If your computer is not
a model in the CF-18Bxxxxxx series, refer to "Port Replicator" in the computer's "Reference
Manual."
<For Microsoft
1
Connect the CD drive.
2
Turn on the computer.
3
Install the driver for the CD drive if necessary.
4
At [Found New Hardware Wizard], select [Install from a list or specific location],
and then select [Next].
5
Place the driver CD-ROM in the CD drive.
® ®
Windows XP Professional or Windows
®
XP Tablet PC Edition>
E
9