JVC KY-F560 Bedienungsanleitung Seite 27

White Spot Correction (continued)
White Spot Correction Messages
Detecting Screen
PIXEL COMPEN
EXECUTING
PIXEL COMPEN
ERROR : LENS NOT CLOSED?
Notes
• The white spot correction feature of this unit does not correct all white spots. Detection and correction of
white spots by this unit is performed under the following conditions. White
spot correction will not be performed under conditions beyond those
stated. In cases where conditions are fulfilled, correction may not be suc-
cessfully performed depending on the nature of the white spots.
In such case, perform the detection again until white spots are detected.
Consult your JVC authorized dealer if white spots cannot be corrected.
Quantity of Detection/Correction: 32 or less
• The screen on the right may be displayed during detection of white spots
in cases when light enters the CCD during detection or depending on the
condition of white spots. In this case, check if there is light entering the
CCD. If the screen is displayed despite that no light enters the CCD,
increase the shutter speed by 1 step and perform detection again.
• During white spot correction, pixel data is obtained via interpolation of
pixel information from the surroundings. Thus data may not be accurate
for fine images.
• Results of white spot detection will be stored until the next detection is
performed.
• During white spot detection, operation via the remote control will be dis-
abled.
Detection Error Screen
Detection Completed Screen
PIXEL COMPEN
OK
TURN POWER OFF
AND ON AGAIN
PIXEL COMPEN
ERROR : COUNT OVER
TURN POWER OFF
AND ON AGAIN
ERROR : LENS NOT CLOSED?
ERROR : COUNT OVER
PIXEL COMPEN
PIXEL COMPEN
TURN POWER OFF
AND ON AGAIN
E-27