Makita DFT041F Betriebsanleitung Seite 6

Reversing switch action (Fig. 4)
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
• When not operating the tool, always set the reversing
switch lever to the neutral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
LED indicator / Beeper (Fig. 6)
LED indicator / Beeper on the tool shows the following functions.
Status of
the LED indicator/beeper
LED indicator
Lights up in
Green
A series of very
Red
short beeps
Blue
White in order.
Lights up in green
for approximately
one second.
Blinks in purple A series of long
slowly. beeps
Lights up in purple. A long beep
Lights up in red and A series of short
green alternatively. beeps
A series of short
Blinks in red quickly.
beeps
6
Function
Beeper
Check LED, light
and beeper
(when pulling
switch trigger for
the first time after
installing a battery
cartridge into the
tool).
Auto-stop
__
fastening
Warning for battery
cartridge capacity
Checking the
remaining battery
capacity, Autostop
Anti-reset of
controller
Failure of motor
Overheat
Lighting up the lamps (Fig. 5)
CAUTION:
• Do not look in the light or see the source of light
directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The light automatically goes out 10 seconds after the
switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp. Be
careful not to scratch the lens of lamp, or it may lower
the illumination.
Status
Make sure that green, red,
blue, white LED lights up
and beeper beeps properly.
This function works when
the tool has reached the
preset fastening torque
and normal tightening has
been completed. This
helps overtightening to be
avoided.
This indicates the
appropriate time to replace
the battery cartridge when
the battery power
becomes low.
This function works when
the battery power is almost
used up. At this time, tool
stops immediately.
This function works when
an abnormal drop of the
battery voltage occurs for
some reason and the tool
stops.
This function works when
motor fails.
This function works when
the temperature of the
controller or motor goes up
very highly, and the tool
stops.
Action to be taken
__
__
Replace the battery
with fully charged one.
Replace the battery
with fully charged one.
Replace the battery
with fully charged one.
Take it to a Makita
Authorized Service
centers.
Remove the battery
cartridge immediately
and cool the tool
down.