Search Mode - Hama FTA Benutzerhandbuch

f DiSEqC 1.0, 1.1
The receiver is designed to be DiSEqC 1.0, DiSEqC 1.1 & ToneBurst compatible.
This allows multiple antennas to be connected to the receiver at the same time. You can
connect two or more fixed antennas or LNBs with DiSEqC 1.0 or ToneBurst or DiSEqC 1.1
switch. Select from 1 to 4 of DiSEqC 1.0 / ToneBurst command, 1 to 16 of DiSEqC 1.1 com-
mand or NONE according to the option of the configuration of DiSEqC switch box or
antenna.
f DiSEqC 1.2
If your antenna is with DiSEqC 1.2
Motorized system, then you can select the
DiSEqC 1.2 function to ENABLE. The DiSEqC
1.0, 1.1 will be changed to DISABLE.
The Motor means DiSEqC 1.2 you can
change position of your Motor through the
options:
- Movement
In case of User mode, the movement is
adjustable by fine-tuning.
In case of Installer mode, the movement is adjustable by East, West going command.
- Motor Control
GOTO = Move the motor to the stored position of the selected satellite.
STORE = Stores the current position of the motor for the selected satellite.
RESET = Reset all stored position of the motor relative to the "0" position
(Installer mode only).
RECALCULATE = Recalculates the position of the STAB Rotor Motor.
LIMIT E, W = Limits East and West position.
LIMIT OFF = Setting of the limitation to be OFF.
GOTO REF = Goes to the reference position of the Motor.
- Command Mode
Change the current mode between User and Installer modes. In case of User mode, this
is used to search for the position of the motor for better reception.
In case of Installer mode, this is used to search for the position of a satellite manually.
CH SEARCH
f SATELLITE
Press OK button to display the Satellite List
box. The Satellite name is listed in orbit
position. Select one of the pre-programmed
satellite from the list.
If the satellite is not in the list, you can add
the SATELLITE in the SAT/TP EDIT Menu.
f SEARCH MODE
By using the V-/V+ ( / ) button you can
select the searching mode :
- MANUAL
- AUTO
- ADVANCED
64