Maintenance - Clearaudio Double Matrix Professional Sonic Bedienungsanleitung

7. Maintenance

Changing the microfiber stripes
To change the microfiber stripes, remove the upper arm of
the cleaning and vacuum assembly by loosening the side-
mounted hex screw, then pulling the upper arm gently upwards.
Next, release the microfiber supporters from the upper and
lower cleaning arms by applying a light pressure at the end
of each microfiber supporter, and then remove them (see Fig. 4).
Now peel the old microfiber strips away from their supporters.
Before attaching new microfiber strips, it is important to ensure
that any grease, dust or residual glue from the old microfiber
strips is removed from the microfiber supporter.
Apply new microfiber strips, firmly pressing them onto
the supporters.
We recommend changing the microfiber strips after approx. 100 cleaning programs, though this will
depend on the condition of the records cleaned.
Cleaning and draining the waste fluid tank
Over time it is possible for residue to settle in the waste fluid tank which could potentially block the drain
tube. To avoid this happening you should periodically clean the waste fluid tank.
1. Remove the upper suction arm after loosening the side-mounted screw and pulling it gently and
steadily upwards.
2. Place the filling funnel into the suction tube.
3. To flush the waste tank, we recommend 250 ml warm water, which you pour in the waste tank.
4. Let the warm water sit in the waste tank for approximately 20 minutes, then drain it by removing
the sealing plug from the drain hose and put the end of the drain hose into a bowl (etc.) which is
positioned deeper. Repeat this process until the drained flushing water is clean and does not contain
any reside.
Please note:
If you take the machine into operation again, the drain tube must always be closed by the
stopper, so that the vacuum pump can generate the required vacuum for suction.
Only through this we can guarantee a lasting and full function of your cleaning maschine.
The drain tube at the rear should not be pusehd back into the machine. This could bend the
tube and the leaking fluid could damage the cleaning machine.
Page / Seite 10
Downloaded from www.Manualslib.com
Double Matrix Professional Sonic
manuals search engine
Bedienungsanleitung
Pic. 4: Lift the microfiber supporter by
pressing down on one end.
© clearaudio electronic GmbH 2017
User manaul