Acceptance And Transport; Accepting The Machine; Transporting The Machine - Schwamborn DSM 250 Originalbetriebsanleitung

EN Floor grinding machine DSM 250

6 Acceptance and transport

6 Acceptance and transport

6.1 Accepting the machine

Observe the safety instructions in Chapter 2!
The machine is delivered in a complete and pack­
aged condition from the manufacturer.
1. Unpack machine and check the enclosed deliv­
ery slip to make sure all parts are delivered.
2. Check whether any items have been damaged
in transit.
3. In case of damage, contact the transport com­
pany immediately!
4. Report any problems to the manufacturer imme­
diately!
Complaints at a later date cannot be acknowl­
edged!

6.2 Transporting the machine

Risk of injury from heavy loads!
Suspended loads can fall or tip over, causing
serious injuries!
Do not stand under suspended loads!
Raising and lowering the load must be per­
formed by two persons!
Do not raise loads any higher than necessary!
Prevent the load from swinging back and forth!
Keep sufficient safety distance!
Devices for transporting the unit have to be
rated to handle its full weight and dimensions.
Observe weight data on packaging or in the ac­
companying documentation!
Never walk or reach beneath the load while it is
being lowered.
Wear safety shoes!
Wear protective gloves!
Proceed with the greatest care and caution!
For longer periods in transport or in storage, the
machine needs to be covered to protect it
against soiling.
The machine can be fastened to pallets to protect it
against damages. Relocation over short distances is
possible on the transport wheels.
1. Pull the power plug [16, Fig. D] from the power
outlet.
2. Fasten all loose parts to the machine.
3. either:
— Move the machine to the respective loca­
tion with the transport wheels
[11, Fig. B/C/D] and deposit.
or:
a. Grab the machine by the handle [1, Fig. A]
and transport grip [13, Fig. C] and lift care­
fully.
b. Lift the machine onto a suitable transport
device (e.g. a palette) and lower it.
c. Always secure the machine according to
regulations during transport by a vehicle or
suitable devices and strap down with ten­
sion belts.
d. Move the machine to the respective loca­
tion and deposit.
19