4
Insert the new lamp all the way in until
it is securely in place. Tighten the
2 screws.
5
Close the lamp cover and tighten the
1 screw.
Note
Be sure to install the lamp and Lamp cover
securely as it was. If not, the projector
cannot be turned on.
6
Connect the AC power cord to a wall
outlet and turn on the projector.
7
Reset the lamp timer for
the next replacement time.
Select "Lamp Timer Reset" on the SET
SETTING menu then press the ENTER
key. When a message appears, select
"Yes" to reset the lamp timer.
notification of
Replacing the Lamp
15
GB