How To Use The Safety Stands On The 42-Series Centrifugal Extractor48-Series Centrifugal Extractor - Milnor M7V4836 Serie Handbuch

Chapter 2. Safety
Figure 2: Access Panel Bypass Key Switch and Safety Placard
BIUUUS06 (Published)
2.3. How To Use the Safety Stands on the 42-series Centrifugal
Extractor48-series Centrifugal Extractor
These machines are provided with two safety stands four safety stands—two short (which also
serve as shipping brackets) and two long— (painted red) for maintenance. After the shell is
tilted to the horizontal or full up position, the appropriate stands are placed around the shafts of
the extended hydraulic cylinders and secured in position. With the shell full down, the stands are
mounted to the tilt cylinders, then with the shell raised, the safety bolts are inserted.Use the safety
stands to perform maintenance on the machine when the shell is raised. Use the long or the short
stands as appropriate for the maintenance to be performed.
WARNING 22 : Crush Hazard—The safety stands provide protection against the
un-powered drifting down of the shell during maintenance in the event of a leak in the hydraulic
system.
• Never work under the raised shell unless both safety stands are installed and power is
locked out/tagged out. Do not work near the raised shell with power on unless both safety
stands are installed.
• Install these safety components using the procedure prescribed in this document.
• Maintain these safety components in good condition.
• Designate a convenient, secure area to stow these safety components when not in use.
PELLERIN MILNOR CORPORATION
— End of BICP1S01 —
Book specs- Dates: 20120127 / 20120127 / 20120127 Lang: ENG01 Applic: PVU VJU
17