1.2. General Content Of The Ec-Declaration Of Conformity - Milnor M7V4836 Serie Handbuch

Chapter 1. Machine Description, Identification, and Certification
Figure 1: Machine Data Plate
View of Data Plate (English text shown)
.
Supplement 1
Machines shipped as multiple units for assembly on site (example: CBW tunnel washer) will
have multiple data plates—one for each unit and a master plate for the complete machine,
located on the primary unit. Although each unit can have a different model number, they will
all share the same basic serial number. The basic serial number is usually 8 digits. Some of the
units will have a two-digit suffix at the end of the serial number.
BIPCUL01 (Published) Book specs- Dates: 20120127 / 20120127 / 20120127 Lang: ENG01 Applic: PVU VJU

1.2. General Content of the EC-Declaration of Conformity

Manufacturer Pellerin Milnor Corporation
Hereby we declare under our sole responsibility that the machinery
Type (see the declaration for your machine)
Serial no (see the declaration for your machine)
Manufacturing date (see the declaration for your machine)
is in conformity with the provisions of Machinery Directive (89/392 EEC) as amended.
Pellerin Milnor Corporation certifies that the machine(s) listed above, manufactured in Kenner,
Louisiana, 70063, USA conform(s) as stipulated by schedule of verification of ISO/DIS 10
472-1 of June 1994 Safety Requirements for Industrial Laundry Machine, Part One, Common
Requirements for All Types, ISO/DIS 10 472-3 of June 1994, Safety Requirements for
Industrial Laundry Machine, Part Three: Washing Tunnel Lines and Continuous Towel Lines,
BS EN 294 of 1992 Safety of Machinery, Safety Distances to Prevent Danger Zones Being
Reached by the Upper Limbs, and EN 60204-1 of October 1992, Safety of Machinery,
Electrical Equipment of Machines, Part One, General Requirements. EN50081-1,2
PELLERIN MILNOR CORPORATION
About Machines With Multiple Data Plates
— End of BIUUUF01 —
9
Legend
1. Model number. See
inside the front cover of
this manual.
2. Data that uniquely
identifies your machine
3. Cylinder maximum
rotation speed in
revolutions per minute, if
applicable
4. Cylinder volume in the
units of measure shown,
if applicable
5. Piped utility requirements
6. Hydraulic oil pressure, if
applicable
7. Electrical requirements
8. Part number for
multi-unit machine, if
applicable.