Maintenance - Jung FRWM200 Betriebsanleitung

13 Maintenance

13.1 Maintenance
You must perform visual and functional tests at
regular intervals.
Visual inspection Visual inspection
Perform a visual inspection once a month:
f Make sure that the smoke intake lamella
are not blocked (e.g., by dust, dirt, paint).
f Make sure that the device is not dama-
ged, and is securely mounted on location.
Functional check Functional check
As smoke alarm devices are electronic devices,
trigger a test tone regularly, at least once a year:
f If no test tone sounds, you must replace
the device.
Test tone device Test tone device
Trigger a test tone at least once a year:
f Press and hold the testing / stop button
for about 2 to 3 seconds.
Shor t acoustic signal, single
device
In addition, we recommend checking the functi-
oning of the device twice a year with a „Smoke
Detector Test Spray".
EN
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
Radio group test tone Radio group test tone
Trigger a test tone at least once a year:
f Observe chapter 9.1 „Radio group
connection test" on page 63.
Test tone for shared radio group Test tone for shared radio group
Trigger a test tone at least once a year:
f Observe chapter 9.2 „Shared group
connecting test" on page 64.
13.2 Cleaning
Note the following when cleaning:
f Remove the device from the magnetic
carrier.
f Clean the device with care, e.g. with a
vacuum cleaner and a wet cloth.
71