Alarm Forwarding And Alarm Stop - Jung FRWM200 Betriebsanleitung

10.1 Cancelling a device from a
radio group
You must cancel a device from a radio group in
the following cases:
Remove device from an existing radio
•
group and connect it to another group
Remove the defective device
•
from the radio group
In the radio group from which the device was
removed, you must set all the devices to factory
settings and re-connect them:
f Observe chapter 6.1 „Setting up radio
group" on page 60.
f Observe chapter 7 „Expanding radio group
and learning mode" on page 62.
f Observe chapter 6.2 „Completing radio
group" on page 61.
EN
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
11 Alarm forwarding
and alarm stop
Alarm forwarding takes place in two directions,
with the following forwarding times:
Alarm forwarding within a
•
radio group or a shared radio
group = approx. 20 seconds
Alarm forwarding from a radio group to
•
shared radio group = approx. 60 seconds
There is no alarm forwarding from the shared
radio group to the individual radio groups.
Repeater function Repeater function
Through the repeater function, radio signals are
forwarded from one signalling device through
available devices to unreachable devices.
If you need specific, complex and,
where applicable, cascading connecti-
on functions for the alarm forwarding,
please contact the manufacturer (see
chapter 15 „Accessories, spare parts
and service" on page 73)
65