Expanding Radio Group And Learning Mode; Setting Up Shared Radio Group - Jung FRWM200 Betriebsanleitung

7 Expanding radio group
and learning mode
You can extend an existing radio group by
bringing the radio group in the learning mode.
Observe the following:
(1) Press and hold the radio button with
splint pin on any device until:
All signal LEDs "off"
(2) Release the radio button as soon as the
LED goes out.
5 Device max. 10 minutes in learning
mode.
(3) To add further devices, see steps (5) and
(6) in chapter 6.1 "Setting up the radio
group" on page 61.
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
62
8 Setting up shared
radio group
8.1 Connecting radio groups
To connect radio groups with another, pro-
ceed as follows:
(1) Put the shared radio group into learning
mode.
f See steps (1) and (2) in chapter 7
"Expanding a radio group and learning
mode" on page 63.
(2) In the subgroups to be connected, select
the closest device to the shared radio
group.
(3) Press the radio button with splint pin on
the selected device for 1 second.
5 Sub-group is connected to the shared
radio group.
(4) Repeat the process, if necessary, on
further subgroups.
EN