Restoring Factory Defaults - Jung FRWM200 Betriebsanleitung

9.2 Shared group connecting test
You can check the correct connection of a
radio group to a shared radio group, only on
devices in a subgroup, as follows:
(1) Press and hold testing / stop button of
any device of the subgroup pressed for
approx. 60 seconds.
After approx. 1 second, the test
tone will sound.
After approx. 12 seconds, and
after 60 seconds, the test tone
sounds again.
(2) Release testing / stop button.
All devices in the shared radio
group emit a short test tone.
(3) Repeat the process, if necessary, on
further subgroups.
5 Successful connection test of the
shared radio group.
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
64
10 Restoring factory
defaults
In the following situations, you must restore the
factory settings:
Connection attempt was unsuc-
•
cessful and must be repeated
To remove the allocation of a device
•
to a radio group, e.g. defective device
Proceed as follows:
(1) Pull out activation button.
(2) Press and hold the testing / stop button
for approx. 2 to 3 seconds and then
release.
(3) Press the radio button using a split pin
until the signal LED starts to flash yellow.
(4) Release radio button immediately.
5 The device is in the factory state.
EN