Alarm Stop - Jung FRWM200 Betriebsanleitung

In the radio group from which the device
was removed, you must set all the devices
to factory settings and re-connect them:
f Observe chapter 6.1 „Set up radio
group" on page 60.
f Observe chapter 6.2 „Expand radio
group (learning mode)" on page 61.
f Observe chapter 6.3 „Finalising radio
group" on page 62.
6.9 Alarm forwarding
Alarm forwarding can take place in two
directions, with the following forward-
ing times:
Alarm forwarding within a
•
radio group or a shared radio
group = approx. 20 seconds
Alarm forwarding from a
•
radio group to shared radio
group = approx. 60 seconds
There is no alarm forwarding from the
shared radio group to the individual
radio groups.
66
Operating Manual: FRWM200 - Smoke Alarm Device with Radio Link
Repeater function
Through the repeater function, radio sig-
nals are forwarded from one signalling
device through available devices to un-
reachable devices.
I f yo u n e e d s p e c i fi c , c o m -
plex and, where applicable ,
c a s c a d i n g c o n n e c t i o n f u n c-
tions for the alarm forwarding,
please contact the manufacturer
(see chapter 10 „Accessories, spare
parts and service" on page 73)

6.10 Alarm stop

You can stop an alarm with or without fire.
If there is still a risk of fire after
an alarm stop, the switched-off
devices ring again after 10 minutes.
EN