Handling Batteries; Material Damage; Unpacking, Setting Up And Inserting The Batteries; Mounting The Appliance - Silvercrest SKD 2300 A1 Bedienungsanleitung

RP90866 Konvektor LB4 Seite 6 Dienstag, 9. Juli 2013 11:00 11
• The remote control contains batteries.

4.7 Handling batteries

Caution! To avoid damaging the product
and ensure it functions correctly, please
note:

5.1 Mounting the appliance

Before the appliance can be used, the feet 7
must be screwed on as follows:
1. Unpack
2. Remove the transport packaging.
3. Check that the appliance shows no signs
4. Slide the feet 7 from the outside into the
5. Secure the feet 7 firmly using the screws
6
Downloaded from www.Manualslib.com
Ensure that they are kept out of the reach
of children and are not swallowed.
Ingested batteries can
dangerous. Obtain medical assistance
immediately if batteries are swallowed.
Warning!
To prevent a risk of explosion,
normal batteries must not be
charged, heated or disposed of by
burning.
If battery acid has leaked, avoid
contact with skin, eyes and mucous
membranes to prevent injury. In the
event of contact with the acid, rinse
the affected areas immediately
with plenty of clean water and
contact a doctor at once.

5. Unpacking, setting up and inserting the batteries

the appliance
packaging.
of damage.
corresponding supports
underside of the convector.
supplied.
manuals search engine
• Always replace all batteries at the same
time.
• Do not use different battery types or a
mixture of new and old batteries at the
be highly
same time.
• Do not short circuit the batteries.
• Remove the batteries if the device is not
used for a long time. Leaking batteries
could damage the device.

4.8 Material damage

Caution! To avoid material damage,
please observe the following conditions.
• Remove the batteries from the remote
control if you are not using it for a
prolonged period of time. Leaking
batteries could damage the remote
control.
• Ensure that the feet are fitted correctly
(see "5.2 Setting up the appliance" on
page 6), otherwise the floor might be
scratched or scorched.

5.2 Setting up the appliance

Note: As the appliance and heating
elements are supplied with a thin film of
grease, there might be a small amount of
from the
smoke and odour the first time the appliance
is used. This is not harmful and will stop after
a short while. Please ensure meanwhile that
there is sufficient ventilation.
Warning! Ensure that there is
sufficient distance from the wall,
on the fixtures and other appliances. The
distance must be at least 1 m to
exclude the risk of fire.