Setting The Heat Setting; Thermal Cut-Out; Frost Protection - Silvercrest SKD 2300 A1 Bedienungsanleitung

RP90866 Konvektor LB4 Seite 8 Dienstag, 9. Juli 2013 11:00 11
3. Press

6.3 Setting the heat setting

The appliance has three heat settings:
1. Press button 25 repeatedly until the
2. Press the fan button 15 to switch the fan
6.4 Setting the heating time
The appliance has a timer for setting the
heating time to between 1 and 15 hours.
The appliance switches off automatically
once the heating time has expired.
1. Press timer button 18 repeatedly until
2. To switch off the timer, press timer
8
Downloaded from www.Manualslib.com
the "Reduce temperature"
button 17 to lower the
temperature to a minimum of 5 °C
(41 °F).
Selected specified temperature 20 is
shown in display 5.
– 1,000 watts
– 1,300 watts
– 2,300 watts
desired heat setting is set.
Selected heating level 11 is shown in
display 5.
on or off.
If the fan is switched on, "Fan"
symbol 12 is shown in display 5.
Note: The fan might make a slight
noise, but it does ensure better
circulation of the heated air.
desired running time 19 is shown in
display 5.
button 18 repeatedly until running
time 19 is no longer displayed.
manuals search engine

6.5 Thermal cut-out

desired
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch 9 to "0" to
switch off the appliance.
2. Check whether the air inlet 6 or outlet 4
is obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.

6.6 Frost protection

To prevent the temperature in a room falling
below 0 °C (32 °F), proceed as follows:
1. Press the button for selecting heating
level 25
protection" symbol 13 appears in
display 5.
As soon as the temperature in the immediate
vicinity of the appliance drops significantly
below 7 °C
automatically switches on.
As soon as the temperature rises to above
9 °C (48 °F), the heating switches off and
display 5 shows room temperature again.
2. To switch off frost protection, press the
button for selecting heating level 25
repeatedly
symbol 13 in display 5 disappears.
repeatedly until "Frost
(44 °F), the heating
until "Frost protection"