Programming The Transmitter - elero MultiTel 2 867 MHz Bedienungsanleitung

4.6
MultiTel2_BA_182030001_DE+EN_0514.indb 33 ultiTel2_BA_182030001_DE+EN_0514.indb 33
Downloaded from www.Manualslib.com

Programming the transmitter

A maximum of 15 individual channels is available for
programming receivers. Press the selection key briefl y
to allow all channels to be available for selection for
programming for 30 seconds. After selection of the channel
the programming process can be started with the P key.
All channels will also be displayed during the programming
process if a programming process is started with the P key.
During a programming process the user can switch between
empty and previously programmed channels (except when
programming a channel with more than 10 simultaneous
receivers).
Condition:
The bidirectional receiver is installed.
For programming in front of the programmed blind.
1. With electrical receivers which have already been
installed, switch the fuse off, and on again a few seconds
later. The receiver is now in programming mode for about
5 minutes.
2. Press the programming key P on the back of the device
briefl y (approx. 1 second) until the status display lights
up briefl y. The blind moves up and down for approx. two
minutes, showing that the receiver is in programming
mode.
3. Press the UP key immediately (maximum 1 second) after
the start of a upward movement. The status display lights
up briefl y.
The blind stops briefl y, starts moving again and then
moves downwards.
4. Press the UP key immediately (maximum 1 second) after
the start of any downward movement. The status display
lights up briefl y. The blind stops. The channel is now
programmed by the transmitter.
manuals search engine
Ⓒ elero GmbH
EN | 33
07.01.2015 13:03:24 07.01.2015 13:03:24