Function Menu; Factory Setting; Programming The Transmitter; Programming Additional Transmitters - elero TempoTel 282670001 Bedienungsanleitung

FUNCTION menu

Factory setting

This restores all the hand-held transmitter settings. Only the
receiver allocations are not deleted. All the initial operation steps
must then be carried out.
Version
Indication of the current firmware version.

Programming the transmitter

Requirement
The receiver is installed. Check whether the channel is deleted or in
the correct mode according to the status display.
For programming, position yourself in front of the blind to be
programmed.
1. With electrical receivers which have already been installed,
switch the fuse off, and on again a few seconds later.
The receiver is now in programming mode for about 5 minutes.
2. Press the programming button P on the back of the device
briefly (approx. 1 second). The status display lights up briefly.
The blind moves up and down for approx. two minutes, showing
that the receiver is in programming mode.
3. Press the UP button as soon as the blind starts moving up
(within 1 second at the most). The status display lights up briefly.
The blind stops briefly, starts moving again and then moves
downwards.
4. Press the DOWN button as soon as the blind starts moving
(within 1 second at the most). The status display lights up briefly.
The blind stops. The transmitter channel is programmed.
NOTE
If the blind does not stop, it must be programmed again.

Programming additional transmitters

NOTE
If several receivers are connected to the same feed line, then all
are simultaneously in programming mode.
GB-20 www.elero.com