elero MultiTel 2 867 MHz Bedienungsanleitung Seite 83

MultiTel2_BA_182030001_DE+EN_0514.indb 35 ultiTel2_BA_182030001_DE+EN_0514.indb 35
Downloaded from www.Manualslib.com
If you wish to program additional transmitters to a receiver:
1. Press the UP and DOWN keys and the programming
button P (back of the device) simultaneously (for 3
seconds) on a transmitter that is already programmed
for the receiver. The status display lights up briefl y. The
receiver is now in programming mode.
2. Press the programming button P on the transmitter to
be programmed, until the status display lights up briefl y.
The receiver is now in programming mode (movements
up and down).
3. Press the UP key immediately (maximum 1 second) after
an upward movement has started. The status display
lights up briefl y. The blind stops briefl y, starts moving
again, stops and then moves in the DOWN direction.
4. Press the DOWN key immediately (maximum 1 second)
after the start of a downward movement. The status
display lights up briefl y. The blind stops.
The transmitter is now programmed.
If more than 10 bidirectional receivers are being
programmed at the same time, the transmitter channel in
programming mode switches to group mode. Group mode
is indicated by fast fl ashing with pauses.
Programming in group mode is terminated after 2 minutes
without pressing a key or the joystick or by pressing the
STOP key for 6 seconds.
Important:
For venetian blinds, a jogging mode for quickly reaching
receivers which are further away is not possible in a
transmitter channel with more than 10 programmed
receivers.
manuals search engine
Ⓒ elero GmbH
EN | 35
07.01.2015 13:03:24 07.01.2015 13:03:24