Herunterladen Inhalt Inhalt Diese Seite drucken

Gardena smart Sensor Betriebsanleitung Seite 11

Vorschau ausblenden Andere Handbücher für smart Sensor:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
To select correct location
for Sensor:
To "plant" the Sensor :
8
4
Downloaded from
www.Manualslib.com
ß
1. Push the flap
P
2. Remove the battery holder
3. Insert the batteries into the battery holder
4. Insert battery holder
5. Close the lid
6
5
7
Correct location:
The Sensor must be positioned at a location in the watering area
which is exposed to the same climatic conditions as the plants
(sun, wind, rain, etc.) for which a status is to be displayed.
Incorrect location:
The Sensor should not be covered by neighbouring plants.
Areas of shade should be avoided.
To rule out erroneous reaction results caused by waterlogging,
the Sensor should not be positioned in dips in the ground.
The sensor should not be positioned in places, where lawnmowers
mow.
1. Dig a funnel­shaped hole in the ground
2. Break up the soil
3. If the soil is dry, moisten.
4. Replace the damp broken­up soil
5. Immerse entire sensor tip
6. Insert the Sensor to the upper edge of the sensor
0
7. Press down the soil
8. Water the area around the Sensor with approx. 1 litre water.
HINT: To Connect GARDENA Micro-Drip-System:
To ensure that the quantity of water delivered is registered by the
sensor tip when using the GARDENA Micro­Drip­System, a drip
head should be installed directly above the sensor.
manuals search engine
(5)
and open the lid
When doing so, ensure correct polarity
(7)
in the sensor.
(6)
.
WARNING!
The tip of the sensor will only measure the soil mois-
ture correctly if the sensor tip is in full contact with
the ground on all sides! No air should be trapped at
the sensor tip in the ground.
(8)
removed and take out any stones.
without packing tight.
(8)
broken­up soil
.
Here the sensor tip
(4)
must be in full contact with the damp soil
on all sides.
(8)
around the sensor
The Sensor should not stand loose in the ground.
Depending on the ground it may take several hours until the
Sensor measures the actual soil moisture.
(6)
.
(7)
.
(7)
.
ß
.
P
(8)
at least 12 cm deep.
(8)
in the funnel­shaped hole
(4)
in water (felt must be wet).
(10)
(10)
lightly.
in the
11

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis