Operating Instructions Tsdl; Assembly Guidelines; Cutting; Punching - Weidmuller TSDL Betriebsanleitung

4.

Operating instructions TSDL

4.1

Assembly guidelines

• The longitudinal stop rail (2) must be assembled to
the basic device (1) using the holes (11) provided.
Assemble the slider (3) onto the longitudinal stop
rail (2).
• Using the hole provided (22), screw the lever (4)
onto the basic device (1).
• The cutting and punching device is to be secured
to the top of a bench using the corresponding fix-
ing material and the holes provided on the under-
side of the device (33).
NOTE
The fixing material is not included in
the range of supply!
• The device has been designed as a bench top de-
vice. The device must be physically attached to
the place work.
4.2

Cutting

When cutting, read the measurement to the right of
the slider (3) (marked with SCHNEIDEN), then place
the mounting rail from the front against the limit stop.
It is necessary to raise the limit stop to remove par-
ticularly short pieces of cut-off material from the de-
vice.

Punching

Pull the lever (4) towards you and down; after cut-
ting, return the lever to its starting position.
00/07.12
4.3
When punching longitudinal holes (Y), read the re-
quired measurement on the left of the slider (3)
(marked with LOCHEN), then place the mounting rail
at the Ø 6-mm stop pin (7). In order to guarantee the
exact centre position of the holes, the guide plates
(6) at the insert and removal points of the device can
be set exactly by means of a setscrew.
When punching diagonal holes (X), insert the mount-
ing rail into the corresponding opening in the basic
device. The distance to the end surface is pre-set on
the machine to 8.75 mm.
Cutting
Operating instructions TSDL
Punching
13