Bose FreeSpace FS2P Installationsanleitung Seite 6

Installation
Mounting the Loudspeaker
1. Insert the included suspension cable through the cable fastener and wrap the cable around a support structure; secure the cable
using the cable fastener. Note: Arrows on the cable fastener indicate the cable direction.
A. To loosen the cable, insert the fastener tool into the release hole and adjust the cable.
2. Secure the cable clip to the loudspeaker suspension cable attachment point.
3. Pull the loose end of the suspension cable to adjust the loudspeaker to the desired height. Once you've reached the desired
loudspeaker height, cut away any excess cable.
Note: Trim any frayed filaments with wire cutters after cutting to length.
4. Insert the loudspeaker wiring through the rubber conduit of the input cover (see Preparing the Input Cover on page 4).
5. Wire the connector and insert the connector into the
loudspeaker. For wiring information, see Wiring the
Loudspeaker on page 5.
6. Place the input cover over the connector and press it firmly
against the loudspeaker to create a tight seal. Secure the
input cover using the input cover screw.
7. Use the included cable ties to secure the wiring to the
suspension cable.
Note: Before attaching the grille, adjust the loudspeaker tap
settings to the appropriate setting for the installation. See
Loudspeaker Settings on page 5.
8. Line up the grille with the inside of the loudspeaker enclosure
so that the two smallest grille tabs are on either side of
the tap switch. Push the grille on the loudspeaker until it is
secured into place. If necessary, push the grille tabs inward to
properly fit into the loudspeaker enclosure.
w
r
y
6 • English
q
e
t
i
PRO.BOSE.COM
A
FreeSpace FS2P • Installation Guide