General Introductions; Electrical Information; Important Safeguards - Absaar 1206CS - 6A 12V - 100602 Bedienungsanleitung

1. GENERAL INTRODUCTIONS

- 100602 battery charger has the features of convenient operation, reliable safety
and high quality.
- If battery is over-charged, the charger will keep it at normal current output.
- If short circuit happens, the charger will switch off itself, and return to normal after one or two
minutes..
- The output current of the charger is very stable, so it can protect the battery very well.
- Indication of charging: the charger has two pilot lamps, one is for charging full and the other is
for charging..
2.

ELECTRICAL INFORMATION

WARNING :
Machines that are double insulated, do not require a connection to earth.
If in doubt consult a qualified electrician
The wires are colored as follows:
Blue - Neutral (N)
Brown - Live (L)
Some machines come with an earth wire this is as follows:
Green/Yellow - Earth (E)
Regularly inspect all machines electrical connection and wiring condition for damage.
Any faults detected should be immediately rectified before further use of the machine.
Always have
In use ensure all wiring and extension cords are kept clear of any cutting tools, sharp
objects and any other workshop hazards such as wet floors, chemicals, solvents etc.
To prevent fire or shock hazards do not expose these products to rain or moisture.

3. IMPORTANT SAFEGUARDS

IMPORTANT SAFETY INSTRUCTIONS
1."SAVE THESE INSTRUCTIONS" -This manual contains important safety and operating
instructions for battery charger
2.. Do not expose charger to rain or snow.
3. Use of an attachment not recommended or sold by the battery charger manufacturer may
result in a risk of fire, electric shock, or injury to persons.
4. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger. An extension cord should not be used unless absolutely necessary.
5. Use of improper extension cord could result in a risk of fire and electric shock. If extension
cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape as those of
plug on charger.
b. That extension cord is properly wired and in good electrical condition.
c. That wire size is large enough for AC ampere rating of charger.
5. Do not operate this charger with a damaged cord or plug -replace the cord or plug
immediately.
the wiring checked by
10
a qualified electrician