Pelgrim GKV 100 Anleitung Seite 20

Position the cardan joints over the shafts of
the taps of the hob. Slide the joint
approximately 10 mm over the shaft and
screw tight (see fig. 6).
Install the hob, screw the assembly clamps
tight. If the unit is constructed from thin
material use filling blocks.
Connect the hob to the gas supply and test
to ensure that there are no gas leaks.
Insert the plug of the hob (if present) into the
wall socket.
After having inserted the plug of the oven
into the wall socket, the oven can be
inserted two-thirds of the way into the
cupboard. Take care with the cardan joints;
lift these a little.
Slide the oven further into the cupboard so
that the cardan joints can be mounted on
the control panel. Pay attention to the
OFF position while doing so.
control panel
D
DETAIL D
fig. 11
Assemble the spark switch:
– Remove the stopper from the control
panel.
– Mount the switch on the bracket.
– Screw the bracket with the switch to the
control panel.
Now slide the oven completely into the
cupboard and screw it tight. Assemble the
control knobs.
Replace the saucepan supports and the
burner caps.
After installation check that the appliance
and the burners are working properly; the
gas flames should be regular and stable
when full on and the burners should not go
out when turned to the lowest setting.