In Combination With Building-In Oven - Pelgrim GKV 100 Anleitung

control panel
C
DETAIL C
fig. 8
Remove the bracket and the stopper
covering the hole for the spark switch in
the control panel (see fig. 8). (Only applies
to models with a spark switch.)
fig. 9
Install the hob, screw the assembly clamps
tight. If the unit is constructed from thin
material turn the assembly clamps round
(see fig. 9).
Connect the hob to the gas supply and test
to ensure that there are no gas leaks.
Insert the plug of the hob (if present) into
the wall socket.
After having inserted the plug of the oven
into the wall socket, the oven can be
inserted two-thirds of the way into the
cupboard.
Reattach the assembly plate to the control
panel (see fig. 10). Check to ensure that the
knob of the spark switch (if present) moves
easily.
Screw the oven to the kitchen cupboard.
Replace the control knobs.
After installation check that the appliance
and the burners are working properly; the
gas flames should be regular and stable
when full on and the burners should not go
out when turned to the lowest setting.

In combination with building-in oven

OST 940/943
Remove the saucepan supports and the
burner caps.
Remove the control knobs for the burners
on the control panel.
Unscrew the four cardan joints from the
control panel.
fig. 10