In Combination With Building-In Oven Or Control Panel - Pelgrim GKV 100 Anleitung

4 9 0
A
1 0
m i n m i n
. .
Detail A
Please note:
The area to be cut away at the front (see
fig. 3, detail A) is measured from 10 mm from
the body of the cupboard (cupboard front
without door).
In combination with building-in oven or
control panel
Remove the saucepan supports and the
burner caps.
Unscrew the assembly plate behind the
control panel. Only unscrew the top and
bottom screws (fitted every other one)
(see fig. 4 and 5).
fig. 3
Position the cardan joints (see fig. 6) in
sequence over the shafts of the taps of the
hob. Slide the joint approximately 10 mm
over the shaft and screw tight.
fig. 4
Assemble the spark switch following the
diagram (see fig. 7). (Only applies to models
with a spark switch.)
fig. 5
fig. 6
fig. 7