Mounts - GeoMax ZEL400HV Gebrauchsanweisung

Using the
ZDR300 in
remote control
mode
To change the
battery

3.2 Mounts

Universal Mount
Grade Mounts
Accessories
The ZDR300 can be used to stop or start rotation, increase or decrease rotation
speed, and move the square shot or stationary point left or right. It also
controls scanning and calibration.
To use it as a remote control, press any key (except On/Off).
If in detection mode, press On/Off to change to the remote control functions.
To install a new 9V (LR6) battery, open the compartment on the back of the
detector. First raise the left side of the cover, then the right side, and lift out.
Follow the polarity indications inside (- is next to the side wall of the detector).
The universal mount can be used as a wall mount and for vertical setups on a
tripod. It features sturdy, all metal construction, with a spring-activated mech-
anism that allows you to easily change height for quick set-ups. Also, it has a
fine adjustment screw on the bottom for precise positioning.
• As a wall mount, it can be attached to a grid for suspended ceiling setup.
• The GeoMax wall mount can also be used on its side and attached to a
tripod (5/8") to hold the laser in the vertical position.
Adjustable grade mounts are used to lay out inclined planes, such as cathedral
ceilings. The ZEL400HV must be in manual mode when using grade mounts.
ZEL400HV | 18