M-system MGK 603 Gebrauchsanweisung Und Installationsanleitung Seite 85

LIGHTING GAS BURNERS
Models without electric ignition
To light one of the gas burners, hold a
flame (e.g. a match) close to the top part
of the burner, push in and turn the
relative knob in an anti-clockwise
direction (fig. 2.1), pointing the knob
indicator towards the large flame symbol
(i.e. max. gas flow).
Models fitted with electric spark
lighter button
On these cooker tops, to light one of the
burners you have to push in and turn the
relative knob to the maximum aperture
position (large flame symbol) and press
the electric lighter button until the flame
has been lit.
Adjust the gas valve to the desired posi-
tion.
Models fitted with electric lighter
incorporated into the burner
knobs
The electric ignition is incorporated in
the knobs ( symbol beside flame
max. heat/max. gas flow fig. 2.1).
To light one of the gas burners, push in
and turn the relative knob to the maxi-
mum aperture position (large flame sym-
bol) and hold the knob in until the flame
has been lit.
The sparks produced by the lighter situ-
ated inside the relative burner will light
the flame.
Adjust the gas valve to the desired posi-
tion
N.B. If your local gas supply makes it
difficult to light the burner with the knob
set to maximum, set the knob to mini-
mum and repeat the operation.
LIGHTING GAS BURNERS
FITTED WITH SAFETY VALVE
DEVICE
In order to light the burner, you must:
1 – Turn the knob fig. 2.2 in anti-clock-
wise direction up to the maximum
aperture (symbol
hold the knob; this will light the gas.
In case of black-out, bring a lighted
match close to the burner.
2 – Wait about ten seconds after the
gas lighting before releasing the
knob (starting time for the valve).
3 – Adjust the gas valve to the desired
power.
If the burner flame should go out for
some reason, the safety valve will auto-
matically stop the gas flow.
To re-light the burner, return the knob to
the closed
minute and then repeat the lighting pro-
cedure.
If your local gas supply makes it difficult
to light the burner with the knob set to
-
maximum, set the knob to minimum and
repeat the operation.
) , push in and
position, wait for at least 1
85