,SETUP – INPUT CONFIG – CONTROL
If the RF module is installed, than you can choose one of two settings: RC and W-DMX.
The desired mode must be choosed.
RC mode: received the data from paired RF remote controllers.
W-DMX: Receives the W-DMX-signal, or receives the W-DMX-signal of a MASTER-Controller or send the
W-DMX signal if setted to MASTER-mode.
NOTE: In W-DMX-mode receiver and transmitter must be setted to same frequency. This can be done in the
specific menu.
You can leave this mode at any time without saving changes by pressing the ESC button.
MBN GmbH, Balthasar-Schaller-Str. 3,
automatically return to the single program or the manual colour selection.
Return to single programs or manual colour is only manually poossible.
In combination with RF remote controller and RF Receiver 2G it is possible to
switch automatically between DALI-signal and RF remote control.
www.proled.com
Bedienungsanleitung / Users manual
SELECTION,
86316 Friedberg - Germany
53