difference between slave device and DMX address is, that when configuring the slave devices the
DMX address is always changed in steps of 4. This is a simplification when you have to configure
many devices (e.g. in master-slave mode).
Press the ENTER button to save the changes. You can leave this mode at any time without saving
changes by pressing ESC button.
,MAIN MODE –
Here the current intensity values of the channels (for example RGBW) are displayed. The numbers indicate
the intensities from 0 to 100.0%.
Press the ENTER button and channel will be inverted. Now you can adjust the value with the UP/DOWN
buttons. By pressing the ENTER button again you can select the next channel. After the last channel, all
channels will be inverted and can be changed together. At any time you can hold UP and DOWN-buttons
together for 2 seconds, to invert all channels. Here you can change the values of all four channels together.
After additional pressing, all channels are deselected.
You can leave this mode at any time without saving changes by pressing the ESC button.
MBN GmbH, Balthasar-Schaller-Str. 3,
MANUAL,
Press UP +
DOWN-button
ca. 2 seconds
www.proled.com
Bedienungsanleitung / Users manual
86316 Friedberg - Germany
46