Bedienungsanleitung / Users manual
Without GAMMA-correction (GAMMA=1) the changings are linear. But the linear change on output doesn't
look linear for human eye. It looks like in the lower brightness the changings are faster than at higher
brightness. The advantage is to let the changings looks for human eye like a linear changing. To allow this
GAMMA-correction is needed. The presetted GAMMA-value is 2,6. This is optimum for the most cases.
Depending on cable length or LED amount, it might be necessary to adjust this value to gain a optimum
result.
,SETUP – OUTPUT – SOFT
CHANGE,
To make a smoother changing between two settings, you can adjust here the time.
Press the UP/DOWN-button to change the time between 2 ms and 250 ms.
Press ENTER-button to save the setting and return to main menu.
NOTE: LEDs change there intensity immediately, if a value is changed. This is one of the biggest differences
comparing to standard bulbs. Sometimes it can be important to emulate the performance of standard bulbs.
The presetting of 100 ms is optimum for the most LED strips. You can choose the optimum setting for
yourself.
MBN GmbH, Balthasar-Schaller-Str. 3,
86316 Friedberg - Germany
51
www.proled.com