Milwaukee SG 6-125 QX Bedienungsanleitung Seite 5

Symbology
Revolutions per Minute
Read Operator's Manual
Volts Alternating Current
A B E
1 - Tool Rest
2 - Guard Assembly
3 - Faceplate
4 - Wing Nuts
5 - FIXTEC Nut
6 - Outer Flange
7 - Type 4 Conical Grinding Wheel
8 - Inner Flange
9 - Spindle Housing
(Insulated Handle)
10 - Trigger
11 - Quik-Lok
12 - Lock On Button
13 - Guard Clamp
14 - Wire Wheel
B
Assembly
WARNING!
Wear safety goggles or glasses with
side shields. Always unplug tool before
attaching or removing accessories. Only
5223-50
CE Conformity Mark
Double Insulated
No Load
SEMKO Safety Mark
Maximum Diameter
Amperes
Watts
Direction of Rotation
5223-50
®
Cord
use accessories specifically recom-
mended for this tool. Others may be
hazardous. Protect others in work area
from debris such as chips and sparks.
Provide barriers or shields as needed.
Installing Guard Assembly
1. Unplug tool and lay it on its tool rest.
2. Loosen guard clamp.
3. Position guard clamp over the spindle
housing and against the housing shoul-
der as shown.
4. Position guard so that operator is always
behind the guard. The open edge of the
guard should face the workpiece.
5. Tighten guard clamp.
WARNING!
To reduce the risk of injury, the wheel
guard must be flush with the spindle
housing as shown.
Removing and Replacing
C
Quik-Lok
MILWAUKEE'S exclusive Quik-Lok
provide instant service replacement.
1. To remove the Quik-Lok
cord nut 1/4 turn to the left and pull it
out.
2. To replace the Quik-Lok
connector keyways and push the con-
nector in as far as it will go. Turn the
cord nut 1/4 turn to the right to lock.
Accessory Selection
WARNING!
To reduce the risk of injury and damage
to the tool, use ONLY accessories rated
at or above the RPM listed on the tool's
nameplate.
Grinding Wheel Selection, Care and
Testing
Use wheels that:
• are high strength
• are resinoid bond
• are the correct size
• have blotters that cover the entire flange
contact area
3
® Cords
®
®
Cord, turn the
®
Cord, align the
English
Cords