Siemens SITRANS L 260 Handbuch Seite 9

Connecting PROFIBUS PA
Typical PLC connection with PROFIBUS PA
SITRANS
LR260
(PROFIBUS PA)
Wiring setup for hazardous area installations
Instructions specific to hazardous area installations
(Reference European ATEX Directive 94/9/EC, Annex II, 1.0.6)
A5E32114443
Downloaded from www.Manualslib.com
active PLC
PROFIBUS PA
SITRANS
LR260
(PROFIBUS PA)
The nameplates shown are typical examples. In all cases, check the nameplate on your
instrument, and confirm the approval rating.
Installation shall be performed only by qualified personnel and in accordance
Note:
with local governing regulations.
The following instructions apply to equipment covered by certificate number
Sira07ATEX9256X:
1. For use and assembly and details of marking/coding, refer to the main instructions.
2. The equipment is certified for use as Category 1D, 1/2D and 2D equipment and may
be used in hazardous zones 20, 21 and 22 with dusts.
3. This equipment has a maximum surface temperature of T100 C (in an 80°C ambient).
Refer to the applicable code of practice for selection of this equipment with respect
to specific dust ignition temperatures.
SITRANS LR260 (PROFIBUS PA) – QUICK START MANUAL
manuals search engine
PDM
PROFIBUS DP
DP/PA
coupler
PC/laptop
SITRANS
LR260
(PROFIBUS PA)
Page EN-7