OHAUS Scout SJX Serie Bedienungsanleitung Seite 6

TM
SCOUT SJX SERIES BALANCES
1
Notes: Short Press: Press less than 1 second.
2
Long Press: Press and hold for more than 2 seconds.
3
Extended Press: Press and hold for more than 5 seconds.
1
2
3
4
5
6
Item Description
1 Battery charge symbol
2 Stable weight symbol
3 Negative symbol
4 Center of Zero symbol
5 NET symbol
6 Preset Tare symbol
7 Pointer symbols
3.2 Turning Balance On/Off
To turn the balance on, press and hold the On/Zero Off button for 1 second. The balance
performs a display test, momentarily displays the software version, and then enters the active
weighing mode.
To turn the balance off, press and hold the On/Zero Off button until OFF is displayed.
3.3 Calibration Operation
When the balance is operated for the first time, a span calibration is recommended to ensure
accurate weighing results. Before performing the calibration, be sure to have the appropriate
calibration weights. Ensure that the Security switch is set to unlocked position.
SJX/E:
Press and hold Menu until [m m MeNU] (Menu) is displayed. When the button is released, the display
will show [C.A.L]. Press Yes to accept. [SpaN] will then be shown. Press Yes to begin the span
calibration.
[--C--] will be displayed while zero reading is stored. Next, the display shows the calibration
weight value. Press the No key toggle the value. Place the specified calibration mass on the
pan. [--C--] will be displayed while the reading is stored. The display will show [done] if the
calibration was successful. The balance returns to the previous application mode and is ready
for use.
1.800.561.8187
7
Figure 3-2. Scout Display
TABLE 3-2. Display Symbols
Item Description
8
9
10
11
12
13
www.
Kilogram, grain symbols
Check Weighing symbols
Pound, Ounce, Pound:Ounce symbols
Percent, dwt, g/mol symbols
G (Gravity), Pieces, t hk, t sg, t tw, H ( Hold)
symbols
Newton, Totalization, Dynamic, Bluetooth
symbols
information@itm.com
.com
EN-5
13
12
11
10
9
8