OHAUS Scout SJX Serie Bedienungsanleitung Seite 21

EN-20
7.3 Compliance
Compliance to the following standards is indicated by the corresponding mark on the product.
Mark Standard
This product conforms to the applicable harmonized standards of EU Directives
2011/65/EU (RoHS), 2014/30/EU (EMC), 2014/35/EU (LVD) and 2014/31/EU (NAWI).
This product complies with the EU Directives 2012/19/EU (WEEE) and 2006/66/EC
(Batteries). Please dispose of this product in accordance with local regulations at
the collecting point specified for electrical and electronic equipment.
AS/NZS 61000.6.1, AS/NZS 61000.6.3
CAN/CSA-C22.2 No. 61010-1, UL Std. No. 61010-1
Important notice for SJX...M... verified weighing instruments in the EU
When the instrument is used in trade or a legally controlled application it must be set up, verified
and sealed in accordance with local weights and measures regulations. It is the responsibility of
the purchaser to ensure that all pertinent legal requirements are met.
Weighing Instruments verified at the place of manufacture bear the following supplementary
metrology marking on the descriptive plate.
Weighing Instruments to be verified in two stages have no supplementary metrology marking on
the descriptive plate. The second stage of conformity assessment must be carried out by the
applicable weights and measures authorities.
If national regulations limit the validity period of the verification, the user of the weighing
instrument must strictly observe the re-verification period and inform the weights and measures
authorities.
As verification requirements vary by jurisdiction, the purchaser should contact their local weights
and measures office if they are not familiar with the requirements.
FCC Compliance Statement:
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
1.800.561.8187
www. .com
TM
SCOUT SJX SERIES BALANCES
information@itm.com