Adjusting The Balance; Adjusting The Height - Sunny SF-B1423C Montageanleitung

ADJUSTMENTS & USAGE GUIDE

ADJUSTING THE BALANCE

In order to achieve a smooth and comfortable ride, you must ensure that the
bike is stabled and secured. If you notice that the bike is unbalanced during
use, you should adjust the foot levelers located beneath the front and rear
stabilizers. To do so, simply rotate the Foot Leveler (No. 74) until the bike
becomes levelled with the floor surface. If required, repeat this process to
74
adjust the remaining foot levelers.
ADJUSTING THE TENSION & EMERGENCY STOP
Adjust the tension by rotating the Tension Control Knob (No. 15) clockwise
15
to increase the level of resistance. Rotate the Tension Control Knob (No. 15)
counter-clockwise to decrease the level of resistance. Push down on Tension
Control Knob (No. 15) to enforce the brake and stop the bike immediately.
ADJUSTING THE ANGLE OF THE SEAT
Use Spanner (No. 88) to unscrew the nut under the seat. Adjust the seat to
the desired angle and reinstall the nut. Check the nut periodically to ensure
that it is tight and secure. Use the Spanner (No. 88) to tighten when
necessary.
Note: You will need to tighten the nut on the opposite side at the same time.
The use of an additional wrench is required.
MOVING THE BIKE
To move the bike, first ensure that the handlebar is properly secured. If the
handlebar is loose, tighten the Adjustment Knob (No. 38) to secure it. Next,
stand at the front of the bike so that you're directly in front of the handlebar.
Firmly grasp and hold each side of the handlebar, place one foot on the Front
Stabilizer (No. 73), and tilt the bike towards you until the transportation
wheels on the Front Stabilizer (No. 73) touch the ground. With the wheels on
the ground, you can transport the bike to the desired location with ease.

ADJUSTING THE HEIGHT

I II
Loosen and pull out the [seat height] Adjustment Knob (No. 38) to adjust the
height of the seat. You may also slide the seat forwards or backwards by
loosening and pulling out the [seat] Adjustment Knob (No. 38) on the Seat
Slider (No. 36). You may adjust the height of the handlebar by using the
[handlebar] Adjustment Knob (No. 38). When making adjustments, you will
see a limit on the seat post, seat slider and handlebar post. DO NOT lift the
posts passed this mark. Always check the Adjustment Knobs (No. 38) to
ensure that they are fully secured when you finish making an adjustment.
14