Adjusting The Seat; Adjusting The Handlebar - Sunny SF-B901 Bedienungsanleitung

ADJUSTING THE SEAT

The seat of this bike is fully adjustable as it moves Up,
Down, Fore (forward), Aft (backward).
To adjust the height of the Seat Post (No. 2), loosen and
pull the [seat post] Knob (No. 23) outward, then raise or
lower the seat to the desired height. Once adjusted, re-insert
and tighten the [seat post] Knob (No. 23) to secure the seat
in place.
23
To adjust the seat back and forth, loosen and pull [seat
slider] Knob (No. 23) outward, then slide the Seat Slider
(No. 3) to the desired position. Once positioned, re-insert
and tighten the [seat slider] Knob (No. 23) to secure the seat
slider tube in place.

ADJUSTING THE HANDLEBAR

It is important that the handlebar and seat are both set to the
correct height of your body. To adjust the handlebar height,
loosen and pull the Knob (No. 23) outward, then slide the
Handlebar Post (No. 4) up or down to the desired height.
Once adjusted re-insert and tighten the Knob (No. 23) to
secure the handlebar post in place.
CHECKING BRAKE PADS AND PEDALS
Ensure all the Nuts, Nut Caps and Pedals are secured and
inspect the equipment regularly. If you should find any
defective parts, do not exercise until they've been repaired.
Pay close attention to easily damaged parts due to wear and
tear. Please inspect Brake Pads (No. 41) to ensure there is
still adequate padding on each side before exercising. Make
sure to replace brake pads as necessary. Also, inspect the
Pedals before exercise. If they have become loose, please
re-tighten.
TIGHTENING THE SEAT
Please adjust the Hexagon Nuts by using the Wrench (No.
75) if the Seat (No. 22) is loose.
NOTE: In order to properly tighten the seat, it is important to
note that you will need two open faced wrenches (1 for each
side) and will need to tighten the nut on each side
simultaneously, working in opposite direction of each other.
13