Replacing Battery - m&h IRP60.00 Betriebsanleitung

Operation
3.2.4

Replacing Battery

Risk of damage to the equipment
•
Clean and dry the tool setter well before opening!
•
Do NOT blow off with compressed air!
•
Replace empty battery immediately!
1. Carefully slide the battery compartment sleeve upwards (Fig. 16).
The Tool Setter IRT65.00 is protected against wrong polarity. Therefor there is no need to pay attention to the
polarity when inserting a new battery!
2. Take the used battery out of the battery compartment and insert a new battery (Fig. 16).
Risk of damage to the equipment
•
When closing the battery compartment, ensure the O-ring is properly seated!
3. Carefully slide the battery compartment sleeve down (Fig. 16).
Battery Replacement
60
NOTICE
INFORMATION
NOTICE
O-Rings
IRT65.00
Battery compartment sleeve
Battery (3,6 V / ½ AA)
(4316)