Operation; Tools, Measurement- And Test-Equipment; Changing Stylus - m&h IRP60.00 Betriebsanleitung

Operation

3.2 Operation
3.2.1

Tools, Measurement- and Test-Equipment

Order No. Description
35.20-CP Calibration pin
1780 Hexagon key AF 3 mm
0227 Hexagon key AF 1.3 mm
0885 Mounting pin
3079 Dial gauge
3.2.2

Changing Stylus

1. Loosen the grub screws D, E and F (refer to Fig. 14) and remove the cylindrical stylus together with the break
shaft from the break shaft adapter.
2. Loosen the grub screws A, B and C of the cylindrical stylus (refer to Fig. 14) and remove the break shaft.
3. Insert the new break shaft into the stylus first and tighten the grub screws in sequence A, B, C.
4. Install the cylindrical stylus together with the break shaft to the break shaft adapter and tighten the grub screws
in sequence D, E, F.
5. Check the alignment of the measuring surface (refer to chapter 3.2.5).
6. Calibrate Tool Setter (refer to chapter 3.2.6).
Break shaft - High Force
(91.00-S-HF)
Stylus Change
58
C
B
A
D
E
F
Illustration
Cylindrical stylus
(91.00-D13/24,5)
Grub screw M2,5x3
(0548) (6x)
M=0,35 Nm (0.26 lbf.ft)
Hexagon key AF 1.3 mm (0227)
IRT65.00