Casualplay Avant Bedienungsanleitung Seite 22

NOTE: take care when fitting the harness to make sure that the straps are not twisted.
• For the harness to be fitted, position the harness on the seat of the Avant, so that the
buckle is facing upwards.
• Insert the crotch strap through the mnattress pad and the seat.
• Do the same with the two abdominal straps and the two chest straps.
• The chest straps can be placed in 3 different positions, depending on the child's height.
The chest straps should be positioned at the height of the child's shoulders and both
straps should be at the same level.
• Fit the chest pads.
Removing/fitting the mattress pad
• Unfasten the 6 press studs on the back of the backrest.
• Then unfasten the 4 side studs and the 4 studs underneath the seat.
• Lastly, pass the harness buckles through the openings in the seat and the mattress
pad.
• To fit the mattress pad follow the same steps in reverse, fitting the harness last.
NOTE: take care when fitting the harness to make sure that the straps are not twisted.
Unisystem
• This exclusive fastening system means that the following complements can be used
on the Avant pushchair: sono, prima, prima fix, nuno/folk, baby 0+, newmoon,
metropol.
• The procedure for fitting all of them is the following:
• Put the parking brake on.
• Place the sono, prima, prima fix, nuno/folk, baby 0+, newmoon, metropol on the
pushchair, facing backwards.
NOTE: THE HANDLE OF THE BABY ZERO PLUS SHOULD BE SET TO THE
CARRYING POSITION WHEN IT IS USED WITH THE AVANT.
• Line the fasteners of the sono, prima, prima fix, nuno/folk, baby 0+, newmoon,
metropol up with the slots.
• Press downwards until it clicks into place (fig. 25).
• To remove it, press and then release the red button on both fasteners and pull upwards
to release it from the chassis of the pushchair (fig. 26).
NOTE: THE AVANT CAN BE FOLDED WITHOUT THE SEAT OR WITH THE
SEAT FACING FORWARDS OR BACKWARDS. IT CAN NOT BE FOLDED
WITH THE COMPLEMENTS.
20
(illustrations 25–26)
(illustration 24)