Werbung
Verfügbare Sprachen
Verfügbare Sprachen
________________________________________________________________________________
When Measuring Moisture in
Oil
- The measurement should be done in a
location that provides a representative
sample of your entire oil system (for
example, a high flow feed line or return
line to reservoir). The sensor reads that
which it is in contact with only.
- Locations to avoid include the bottom of
oil reservoirs and bends in a pipeline
where free water may settle out as well as
areas where heavy air bubbling could
occur due to turbulence caused by pumps
or agitators.
Operation
4 ___________________________________________________________________ M210742EN-A
Figure 3
Inside of the Open Transmitter
Numbers refer to Figure 3 above.
1
=
Service port (RS-232)
2
=
Dip switches for analog output settings
3
=
Power supply and signal wiring screw terminals
4
=
Relay/RS-485 module (optional)
5
=
Grounding connector
6
=
Power supply module (optional)
7
=
Relay module/third analog output module (optional)
8
=
Probe
9
=
Output isolation module/DC-DC converter (optional)
10
=
Adjustment buttons with indicator led
Transmitter Housing
Standard Installation
Mount the housing by fastening the
transmitter to the wall with 4 screws, for
example M6 (not provided). Refer to the
User's Guides for the use of the optional
mounting plates.
Figure 2
Standard Mounting
Dimensions (in mm/inch)
0510-026
0503-023
Werbung
