Master CF 75 Bedienungs- Und Wartungsanleitung Seite 13

(maintenance, repairs, etc.) must be
en
carried out by the authorised technical
it
support centre to prevent any risks.
de
••2.9. IMPORTANT: The heater does
not have gas regulators or pipes to
es
connect it to the mains. Therefore,
fr
you will need to contact an authorised
technician for the installation.
nl
••2.10.
IMPORTANT: The heater is
pt
supplied with a specific gas setting.
da
Any kind of change and adjustment
must be performed by an authorised
fi
technician or by the authorised tech-
no
nical support centre. IF ANY CHANG-
ES AND ADJUSTMENTS ARE PER-
sv
FORMED, YOU WILL NEED TO FILL
pl
IN THE NEUTRAL DATA PLATE SUP-
ru
PLIED WITH THE HEATER.
••2.11.
IMPORTANT: The settings of
cs
the supply gas pressure values must
hu
be checked by an authorised techni-
sl
cian.
••2.12.
IMPORTANT: The heater must
tr
be installed exclusively in accordance
hr
with the instructions contained in this
lt instruction manual to prevent any po-
tential fires.
lv
••2.13.
IMPORTANT: Do not use to
et
heat homes or residential buildings;
for use in public buildings, refer to na-
ro
tional regulations.
sk
••2.14.For correct use of the heater
bg
and for preservation of the fuel, follow
all local regulations and the Standard
uk
in force.
bs
••2.15.If the heater is installed in-
doors, it needs an adequate supply of
el
fresh air. It must therefore be used in
zh
rooms with a guaranteed and continu-
ous supply of fresh air. National Stan-
dards in force are valid for installation
and assessment of the supply of fresh
air, including the Technical Standards
and the provisions regarding accident-
prevention and the prevention of fires.
••2.16.The appliance must only be
used as a hot air heater (heating mode)
or fan (ventilation mode). Follow these
instructions scrupulously.
••2.17.Only use fuel, gas pressure val-
ues, voltage and electrical frequency
clearly specified in the data plate ap-
plied on the heater.
••2.18.Make sure the heater is only
connected to suitable mains with a dif-
ferential switch and suitable earthing.
••2.19.It is prohibited to use the heater
in basements and rooms below ground
level.
••2.20.The heater must not be used in
places where explosive dust, fumes,
gases, fuels, solvents, paint, etc. are
present.
••2.21.Whenever the heater is used
near tarpaulins, awnings or similar
covering materials, additional protec-
tion is recommended, such as fire-
proofing. Make sure the hot parts of
the generator are kept at a suitable dis-
tance from inflammable materials (fab-
ric, paper, wood, etc.) or thermolabile
materials (including the power supply
cable). In any case, the distance should
never be less than 3 m.
••2.22.The air vent (lower side) and/
or the air outlet vent (front side) must
not be totally or partially obstructed
for any reason You can use air duct-
ing from or to the heater. The only au-
thorised ducting is the one supplied as
optional items by the manufacturer.
••2.23.If the heater does not switch
on or switch-on is anomalous, please
see the relative section (Paragraph on
"Troubleshooting").
••2.24.The heater must never be
moved, handled or subjected to any
maintenance interventions when run-
ning.
••2.25.Do not open the side inspection
doors and carry out work inside when