Operating And Display Elements; Leds - Feig Electronic OBID i-scan ID ISC.LRU2000 Montage / Installation

OBID i-scan
3

Operating and Display Elements

3.1 LEDs

Table 3-1 shows the LED configuration.
Abbreviation
LED V1 (green)
LED V2 (blue)
LED V3 (yellow)
LED V4 (yellow)
LED V5 (red)
LED V6 (green)
(only device
version with ACC)
Table 3-1: LED configuration
FEIG ELECTRONIC GmbH
Downloaded from www.Manualslib.com
®
"RUN-LED 1"
- Indicates proper running of the internal Reader software (DSP)
Diagnostic 1: RF communication / EEPROM status
Short flashing indicates errorless communication with a
-
transponder on the RF interface
Flashes alternately with V1 after a reset following a software
-
update
Flashes alternately with V1 in case of a data error when
-
reading the parameters after a reset
Diagnostic 2: Host communication
- Short flashing indicates sending of a protocol to the host on the
RS232/RS485 interface
Reserved
Diagnostic 4: RF warning
Comes on during Reader initialization after power-on or after a
-
reset.
- Comes on when there is an error in the RF section of the
Reader. The error type can be read out via software over the
RS232/RS485 interface
"RUN-LED 2"
Indicates proper running of the AC Controller
-
manuals search engine
Installation
Description
Page 49 of 56
ID ISC.LRU2000
M60801-0de-ID-B.doc