Feig Electronic OBID i-scan ID ISC.LRU2000 Montage / Installation Seite 53

OBID i-scan
4.1.1.1 Address assignment of RS485/RS422 for bus operation
For bus operation the Reader can be assigned the required bus address via software.
The address is assigned by the host computer. The software is used to assign addresses "0"
through "254" to the Reader.
Note:
Since all Readers are factory set with address „0", they must be connected and configured
one after the other.
4.1.2 Network connection - LAN
The prerequisite for using TCP/IP protocol is that each device has a unique address on the
network. All Readers have a factory set IP address.
The Readers must be connected and configured one after the other.
Table 4-4: shows the standard configuration of the network connection.
FEIG ELECTRONIC GmbH
Downloaded from www.Manualslib.com
®
Network
IP address
Subnet mask
Port
Table 4-4: Standard configuration of the network connection
manuals search engine
Installation
Address
192.168.10.10
255.255.255.0
10001
Page 53 of 56
ID ISC.LRU2000
M60801-0de-ID-B.doc